So have finally accumulated the bits and pieces for my SE EG project - Blackie (I think I watched too much Twin Peaks leading up to this, plus CRs is called "Snowy" so...). Got a bit of cutting done on the CNC today...

Take 1 - a bit rough, needed to be offset from the edge of the sheet a bit. I'll take it home tonight and work out where the pots need to go (plus a bit of routing in the body...) then make a final file for a good one, either leave it as aluminium (aluminum) or out of black pearloid blank.

Basically I scanned the old pickguard, my partner drew over it in Illustrator, exported as pdf, imported into Rhino, exported into AutoCAD where I drew the pickup cut outs and screw holes. A couple of the outside screw holes are a little bit out (but should still work) but I'll fix those on take 2.