Results 1 to 4 of 4

Thread: 5 way rotary to 3 way toggle

  1. #1
    Junior Member
    Join Date
    Jan 2013
    Posts
    5

    5 way rotary to 3 way toggle

    hi guys just wondering can i put in a switchcraft toggle and just wire it up standard. I dont care about the coil tap stuff i just wont traditional lp style switching. I have a 95 model with dragon 1's could i just solder the red and white wires together and tape em off??

  2. #2
    Senior Member jfb's Avatar
    Join Date
    Dec 2012
    Location
    O'Fallon, MO
    Posts
    5,693
    I just bought the 3 way toggle and push/pull drop in kit they sell on the PRS store and had a local tech swap it with the 5 way rotary knob setup.
    Plank Owner

  3. #3
    Senior Member garrett's Avatar
    Join Date
    Jul 2012
    Location
    Atlanta, GA
    Posts
    993
    You'll have to open up the hole a little bit to fit the toggle. It's not a big deal, but if you don't trust yourself to remove a little wood, take it to a good tech.

    I wouldn't solder the unused wires. Just twist them together and wrap with electrical tape. It'll make things easier if you ever convert back to rotary or if you decide to add coil splits later.
    --Garrett--

  4. #4
    Senior Member Rango's Avatar
    Join Date
    Aug 2012
    Location
    The FAR SIDE of the Middle of Nowhere
    Posts
    970
    Using the factory kit seems like a "no-brainer".

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •