locking tuners

[axe24]

Is there anyway possible to have phase 111 locking tuners,on the prs,SE .

[lgk1208]

Yes, but you'll have to drill new holes and fill in the old ones. Not a direct replacement.

[axe24]

I caint drill out original holes,or is that what u meant.thanks for inpert.

[CoreyT]

New holes have to be drilled, and the old ones filled in show they do not show.
This is on my SG, as it is the only close up pic I have of new tuners added.
You can see the old holes are filled in.

You do not touch the big holes which are for the shaft.
There are a few brands of locking tuners that drop right in that allow you to use the stock screw holes.
Schaller M6, and Grovers, but I forget the part number for them.

[MOBirds]

Grover 406C Mini Locking Rotomatics are drop in replacement for SE line.

[John Beef]

Winding Strings Around the Tuning Machines

Step by step guide to restringing your acoustic guitar.

Step 1:

Bring the string down the center of the peghead and thread it out towards the tuner's knob.


Step 2:

Leaving a bit of string length to wind around the tuner, bend the string gently towards the top of the peghead.



Step 3:

Pass the string up and under itself.


Step 4:

Keeping tension on both ends of the string, fold the string over itself.


Step 5:

Continue to hold tension on the string and begin to wind.
The string should be wound down the shaft to increase the strings angle over the nut.


The End Result

The strings own winding "clamps" down on it to prevent string slippage.