Thread title says it all. But I can't seem to find that specific information on the PRS website.
I purchased a Paul Allender SE (purple burst) last year as seen is this thread: http://prsguitars.com/forum/showthre...ng-a-signature
In that thread I'm asking bout how to seal Paul Reed's signature, but I eventually purchased the replacement backplate, and while I didn't frame it, I did stick the signed backplate to the wall where I hang the Paul Allender. I do like the framed idea though.
Anywho...... there was a minimum purchase amount when I bought the back plate. Surfing around the PRS shoppe I figured I'd pick up some cleaner, polish, and cloths to get to that minimum. Today upon surfing for a guitar stand I noticed the warnings about the rubber used and how it reacts nitro finishes (reminds me I have to check my wall mount). So I went looking to see what finish I have under the maintenance section. Lo and behold I notice the warning about the PRS brand cleaner and polish actually being "dangerous" for nitro finishes.
So do I have a V12 finish or Nitro finish?
Thanks for any responses
(and thank god (if it is a nitro finish), I'm not too anal about how it looks).