PRS Non-Locking Tuners

  1. Line the up the hole in the tuning peg so that it is pointing at the nut slot.
  2. Pull string through hole and over two fingers (or 1.5”) at the nut. (Actual slack is approximately 5/8” to 3/4")
  3. Bring the end of the string towards the truss rod cover and back under the taught string.
  4. While continuing to pull tight, bend the string back over itself so that the string locks in place when tightened.
  5. Turn tuning peg while making sure that the string wraps under itself as shown.
  6. Bring the string to pitch.
  7. Cut off excess string.